7

Kick starter pedal

Rear brake pedal

Handle bar knob

Speedometer is located on the headlight case and odometer 2. incorporated in the speedometer indicates total distance travelled.

Gear speed range indicators cr- are curved bars shown on the speedometer dial plate to indicate the recommended operating range of the respective gcars. High beam indicator lamp (red) I is located at the right side of the

speedometer.

This lamp will be on when headlight is on high beam.

8

INSTRUMENT AND INDICATOR LAMP

OPERATING INSTRUCTIONS

Speedometer Odometer

Gear speed range indicators
High beam indicator lamp

Key position

Function

I Key removal I

Key can be

removed

Key can not be removed

Key can not be removed

9

Electrical Controls
Ignition Switch

The ignition switch (1) is located on the left side of the main pipe . Functions of the respective switch positions are shown in the chart below.

OFF

-

Electrical circuit is opened, engine will not start

Electrical circuit is closed, engine can be started (for day time opcration)

-

Electrical circuit is closed, engine can be

started (for night time operation)

Headlight Beam Control Switch

The headlight beam control switch (1) is located on the left handle grip. "L" is low beam position (low beam light and taillight on). "H" is high beam light and tail light on. The headlight willonly operate when the ignition switch is in the on position. Refer to ignition switch page 9.

10

Headlight beam control switch
"L" position

"H" position

Horn Button

This is a push button switch (1) located on the right handle grip. When the horn button switch is depressed the horn will operate.

11

Horn button

• MECHANICAL CONTROLS
• FRONT AND REAR BRAKE LEVERS

The front brake (lever 1) is located at the right handle bar grip and rear brake lever is at the left handle bar grip .
Also, the rear brake pedal is located at lhe right foot rest.

12

Front Brake Lever

Rear brake lever

13

Gear change pedal

Gear Change Sequence

Gear Change Pedal

The gear change pedal located near the left foot rest is of the progressive shift, positive stop type, which means one full stroke of the gear change pedal will shift only one gear position. The shifting sequence is arranged as shown in the figure .

Shifting to low from neutral is performed by depressing the gear change pedal; successive shifting into second and top are made by depressing the pedal in sequence. Shifting down in gear is accomplished by lifting up the gear change pedal in successive sequence.

Kick Starter Pedal

The kick starter pedal is located at the right side of the engine .

Operate the kick starter pedal with the right foot, starting from the top of the stroke and following through with a rapid and continuous kick.

14

Choke Lever

The choke lever (1) is located at the left side of the carburetor.

When the choke lever is up (A) (normal driving position), the choke is fully open.

When the choke lever is down (B) the choke is fully closed (cold engine starti ng position).

Choke lever

Seat Latch

The seat latch (1) is located on the left rear end of the seat. The seat can be raising by releasing the seat latch.

15

Seal latch